日本SR株式会社摆动夹具回转夹具AS2B AS4B AS6B使用须知
为了正确使用SR摆动夹具回转夹具AS2B AS2B AS6B系列，一定要注意以下内容
●请务必通过夹紧侧面的指示器确认夹紧量的调整(初期)。另外使用时，紧固高度(L尺寸)的调整量为±3mm。现场调整L尺寸后，请务必实施防松动的三重锁定。
使用注意事项
●由于内置了夹杆退避机构，以防止空夹紧状态下的误动作引起的模具保护，如有必要，请在贵公司对模压件的安装面侧实施加工。关于U槽部的模具夹紧面，请参照NSY。
模具高度(H尺寸)的加工公差请在紧固量(a尺寸)的20%以内实施。
夹具及模具保持力存在±10%以内的偏差，请注意。
气缸内装有固定节流阀。请仅在各夹具需要同步时使用速度调整阀。
日本SR株式会社摆动夹具回转夹具AS2B AS4B AS6B使用须知英文：
Be sure to confirm the adjustment on clamping allowance of clamp (at initial atage) with an indicator located at side of clamp.Incidentally, an adjusting allowance of clamping length (Ldimensions) is ±3mm. After L dimensions are adjusted atsite, be sure to provide a 3-fold lock thereto for prevention of loosening.
As a protection for die against malfunction at an empty clamp condition, it has a built-in clamp rod releasing mechanism. Therefore, it required, work the installing side
of die plate by yourself.Refer to NSY for the face pressure of the metal mold clamp at U-channel block.
The working tolerance of die height (H dimensions) shall be less than ±20% of clamping allowance (a dimensions).Keep in mind that there is a variation of less than ±10% in clamping force and die holding force.The air cylinder has a built-in fixed throttle. When each clamp requires synchronization only, be sure to use a speed control valve