日本SR株式会社 日本SR工程有限公司(中国)

SR摆动夹具回转夹具AS2B AS4B AS6B

日本SR株式会社摆动夹具回转夹具AS2B AS4B AS6B使用须知

为了正确使用SR摆动夹具回转夹具AS2B AS2B AS6B系列,一定要注意以下内容

●请务必通过夹紧侧面的指示器确认夹紧量的调整(初期)。另外使用时,紧固高度(L尺寸)的调整量为±3mm。现场调整L尺寸后,请务必实施防松动的三重锁定。
使用注意事项
●由于内置了夹杆退避机构,以防止空夹紧状态下的误动作引起的模具保护,如有必要,请在贵公司对模压件的安装面侧实施加工。关于U槽部的模具夹紧面,请参照NSY。
模具高度(H尺寸)的加工公差请在紧固量(a尺寸)的20%以内实施。
夹具及模具保持力存在±10%以内的偏差,请注意。
气缸内装有固定节流阀。请仅在各夹具需要同步时使用速度调整阀。

SR摆动夹具回转夹具AS2B AS2B AS6B系列

日本SR株式会社摆动夹具回转夹具AS2B AS4B AS6B使用须知英文:

Be sure to confirm the adjustment on clamping allowance of clamp (at initial atage) with an indicator located at side of clamp.Incidentally, an adjusting allowance of clamping length (Ldimensions) is ±3mm. After L dimensions are adjusted atsite, be sure to provide a 3-fold lock thereto for prevention of loosening.
As a protection for die against malfunction at an empty clamp condition, it has a built-in clamp rod releasing mechanism. Therefore, it required, work the installing side
of die plate by yourself.Refer to NSY for the face pressure of the metal mold clamp at U-channel block.
The working tolerance of die height (H dimensions) shall be less than ±20% of clamping allowance (a dimensions).Keep in mind that there is a variation of less than ±10% in clamping force and die holding force.The air cylinder has a built-in fixed throttle. When each clamp requires synchronization only, be sure to use a speed control valve

滚动至顶部